pfsense default deny rule ipv4. The client I am using is the OpenVPN Android app on a Samsung S20. On the GIF tab, click the " + " link and enter your IPv6 tunnel endpoint information. The first line tell the firewall that IP address 192.168.23.254 is on the side of the em0 interface (em0 is my WAN interface), the second one use this address as . WireGuard Setup guide for pfsense - IVPN You can't edit it and that's on purpose. Additionally, I am seeing traffic blocked under this rule that simply should not be blocked at all. Check the box next to our "Default Deny" rule that we created last step. Click the button next to the first rule in the list to move our rule above it. Go to the IPv4 sub-menu and click Add. This is the behavior of the default deny rule in pfSense. Remove the default allow rules for IPv4 and IPv6 by clicking the button next to the rule. I have 2 wan addresses which I've masked to 123.123.123.90 and 123.123.123.94. To disable the firewall, the following rules have been defined: From my research, that rule means it could not match . Parent Interface should be set to WAN. # default deny rules #-----block in log inet all label "Default deny rule IPv4" block out log inet all label "Default deny rule IPv4" block in log inet6 all label "Default deny rule IPv6" block out log inet6 all label "Default deny rule IPv6" # IPv6 ICMP is not auxilary, it is required for operation # See man icmp6(4) Deny Ipv4 Rule Pfsense Default [GPIXO0] pfsense default deny rule ipv4 - wayback.no [SOLVED] pfSense blocking LAN traffic - The Spiceworks Community Default deny rule IPv4 (1000000103) - Netgate Forum As I am looking at the firewall logs for pfSense, it seems like every single blocked connection is being reported as "Default deny rule IPv4 (1000000103)". r/PFSENSE - 'Default deny rule IPv4' repeatedly blocking IPs even ... [SOLVED] Default Deny Rule